Table of Contents
Advertisement
VIVOTEK
Ceiling/Wall Mount without Mounting Plate
(Choose this mounting type if you want to feed the cables form the bottom of the camera)
1. Attach the supplied alignment sticker for camera base to the ceiling/wall.
2. Using the three circles on the sticker, drill three pilot holes into the ceiling. Then hammer the
three supplied plastic anchors into the holes.
3. Drill a cable hole on the ceiling/wall, and feed the cables through the hole.
4. Connect the two white header connectors to the J12 and J7 connectors.
5. Secure the camera base to the ceiling/wall with three supplied screws.
6. You will find a dessicant bag attached to the camera. Replace the dessicant bag included in
the camera with the one shipped within the accessory bag.
7. Attach the dome cover.
8. Secure the four screws with the supplied stardriver. Make sure all camera parts are securely
installed.
1
2
Header (J7)
4
Header (J12)
IMPORTANT:
Arrange the cables neatly to avoid getting in the way when the dome cover is attached.
12 - User's Manual
5
3
8
7
Advertisement
Table of Contents
