1-22
Dell PowerEdge 4200 Systems Service Manual
Table 1-2. Jumper Descriptions
Jumper
Description
EISA
Clear EISA Configuration
VGA
Integrated video controller
PASSWD
Password enable/disable
CRDBIOS Reserved
RSRVD2
Reserved
RSRVD1
333MHZ
Microprocessor speed
300MHZ
Microprocessor speed
266MHZ
Microprocessor speed
233MHZ
Microprocessor speed
Interrupt Assignments
Table 1-3. Interrupt Assignments
IRQ Line
IRQ0
Generated by system timer
IRQ1
Generated by keyboard controller to indicate that keyboard's
output buffer is full
IRQ2
Generated internally by interrupt controller to enable IRQ8
through IRQ15
IRQ3
Generated by super I/O controller to indicate that device con-
and
nected to corresponding serial port requires service (IRQ3 for
IRQ4
COM2 or COM4; IRQ4 for COM1 or COM3)
IRQ5
Available for use by expansion card unless this IRQ line is used by
secondary parallel port
Default Setting
Not installed (utility settings are
retained at system boot)
Installed (controller is enabled)
Installed (password feature is
enabled)
Not installed (reserved; do not
change)
Not installed (reserved; do not
change)
Installed only if the micro-
processor's internal speed is
333 MHz (when supported)
Installed only if the micro-
processor's internal speed is
300 MHz
Installed only if the micro-
processor's internal speed is
266 MHz
Installed only if the micro-
processor's internal speed is
233 MHz
Used/Available