Table of Contents
Advertisement
X. Wiring
(continued)
The use f the pump outputs are as follows:
a.
System Pump - Pumps water through the radiation. This pump is hydraulically sepa
rated from the boiler pump, either by closely spaced tees, or by a hydraulic separator. The system
pump is always on when the system is responding to a call for CH. Depending on the DHW
configuration, it may also be on during a call for DHW.
b.
DHW Pump ("IWH Circulator") - Pumps water directly through the indirect water heater.
Maximum combined current draw for all circulators is 6.3 FLA. See Section XII of this manual for information on
setting up the pump operation.
2.
Low Voltage Connections – Low voltage field connections on the low voltage PCB are shown in Figure 10.3
and are listed from top to bottom:
• Heat T'Stat - 24VAC heating thermostat (R - 24V "Hot")
• Heat T'Stat - 24VAC heating thermostat (W - Energized or Call for Heat)
• Heat T'Stat - 24VAC heating thermostat (C - 24V Common)
• DHW Stat - 24VAC domestic hot water thermostat (1)
• DHW Stat - 24VAC domestic hot water thermostat (2)
• External Limit - Field supplied low voltage safety limit contacts (1)
• External Limit - Field supplied low voltage safety limit contacts (2)
• Alarm Contact (1)
• Alarm Contact (2)
• EnviraCOM Device (D)
• EnviraCOM Device (R)
• EnviraCOM Device (C)
Figure 10.1: Location of High and Low Voltage Printed Circuit Boards (PCB)
107672-03 - 5/18
HIGH
VOLTAGE
PCB
WIRING COMPARTMENT
COVER NOT SHOWN
WIRING
COMPARTMENT
LOW
VOLTAGE
PCB
83
Advertisement
Table of Contents
