Table of Contents
Advertisement
6. Installations using InnoFlue Flex (Vent Options 20,21,37,38):
WARNING
• InnoFlue Flex may be damaged by handling at low temperatures. Do not bend, uncoil or attempt
to install if it has been stored at a temperature below 42°F without allowing it to warm to a higher
temperature first.
• Do not bend InnoFlue Flex more than 45°.
• Instructions below reference the Centrotherm InnoFlue instruction manual. Not all vent configurations
shown in the Centrotherm manual are listed for use with this boiler.
Refer to Centrotherm InnoFlue Instructions for assembly of all flex components including the chimney cap and
the adaptor to rigid InnoFlue at the base of the masonry or B vent chimney. In addition, observe the following
requirements:
a. Refer to the appropriate Vent option in Tables 7.13b or 7.21 for a list of the principle flex components required.
Rigid vent pipe by the same manufacturer will also be required for the run from the boiler to the base of
chimney.
b. Masonry chimneys cannot be used for an air chase
c. B vent chimneys can only be used for an air chase (Vent options 20, 21) if the B vent has the minimum size
shown in Table 7.13b and is fully accessible for sealing of all joints and seams.
d. When Vent Options 20, 21 are used, install a Tee of the same size at the base of the vent. Route the smooth
section of InnoFlue Flex (3") or Flex Adaptor (2") through a cap in the base of this Tee. Use a Centrotherm
IAWP2P or IAWP03B
support bracket as described in the InnoFlue installation manual.
Connection of the PVC air intake pipe to the side outlet of the tee is made using a cap and a PVC socket x
male thread adaptor (2" or 3", depending on the Vent Option). Cut a clearance hole in the cap for the male
threads. Secure the adaptor to the cap using a 2" or 3" electrical conduit lock nut. Seal all joints with RTV.
62
Asphyxiation Hazard. When using InnoFlue Flex, observe the following precautions:
wall plate and RTV to seal this penetration. Install the Base Support using the Base
107672-03 - 5/18
Advertisement
Table of Contents
