Setup > Wireless (Dcs-1130 Only) - D-Link DCS-1100 User Manual

Section 4 - Configuration
Setup > Wireless (DCS-1130 only)
To set up your IP camera's wireless network interface settings, enable Wireless Settings in this window first, then
enter the required settings.
Site survey: Click the Rescan button to scan for available wireless
networks. After scanning, you can use the dropdown box to select an
available wireless network. The related information (SSID, Wireless
Mode, Channel, Authentication, Encryption) will be automatically filled
in for you.
SSID: The SSID of the wireless access point you wish to use.
Wireless Mode: Use the dropdown box to select the mode of the wireless
network you wish to connect to. Infrastructure is normally used to connect
to an access point or router. Ad-Hoc is usually used to connect directly
to another computer.
Channel: If you are using Ad Hoc mode, select the channel of the wireless
network you wish to connect to, or select Auto.
Authentication: Select the authentication you use on your wireless network - Open, Shared (WEP), WPA-PSK, or
WPA2-PSK.
Encryption: If you use WPA-PSK or WPA2-PSK authentication, you will need to specify whether your wireless
network uses TKIP or AES encryption. If you use Open or Shared authentication, this setting will be automatically set
for you.
Key: If you use WEP, WPA-PSK, or WPA2-PSK authentication, enter the Key (also known as password) used for
your wireless network.
After making any changes, click the Save Settings button to save your changes, or click the Don't Save Settings
button to discard your changes.
D-Link DCS-1100/1130 User Manual 22