Removal Of Motor Hub - Sunrise Medical Quickie Q700M Service Instructions Manual

Removal of motor hub

Preparation
Note! Switch off the wheelchair via remote control
Instructions
Note! Suitable work area required!
• Follow the illustrated instruction for removing the motor
hub from the base of the wheelchair.
• Rebuild the wheelchair in reverse order once completed.
• In order to complete this, you must first remove the drive
wheel
Fig. 6.2.46
1. Unscrew and remove nut (A) and washer
Tightening torque for (A) bolts is 60Nm.
Fig. 6.2.47
2. Using the gear puller, pull the hub (B) away from the tapered
shaft of the motor
Fig. 6.2.48
3. Remove motor hub (B)
NOTE: When refitting motor hub, please slide motor hub onto motor
shaft aligning the key way, fit washer and nut and then tighten
Q700M Rev.A
Tools used
19
A
B
2
Fig. 6.2.46
1
Fig. 6.2.47
Fig. 6.2.48
B
3
35