Connection To Computer - Cembre B-TC550NA Operation And Maintenance Manual

– With an 6 mm allen key, unscrew 4 screws (16), remove the two holding plates (17) and the upper
blade (2).
– Insert the new blade, noting the position of the cutting edge bevel.
– Fit the 2 holding plates (17) and secure with 4 screws (16) with relevant washer (18).

5. CONNECTION TO COMPUTER

The memory card integrated in the tool records operating data for transfer via the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area, then
download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download from here, will optimise
the tool's performance.
mini-USB
FIG. 8
– Following information applies in member states of the European Union:
USER INFORMATION in accordance with "Directives 2011/65/EU and 2012/19/EU."
The 'Not in the bin' symbol above when shown on equipment or packaging means that
the equipment must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescribed
guidelines for its separate collection. Appropriate waste separation, collection, environmentally compat-
ible treatment and disposal is intended to reduce harmful environmental eff ects and promote the reuse
and recycling of materials contained in the equipment. Unlawful disposal of such equipment will be sub-
ject to the application of administrative sanctions provided by current legislation.
9
FIG. 7
Screw
B-TC550NA
B-TC550NA
: To access the mini-USB
port (Ref. to fi g. 8) and connect the USB
cable to the computer it is necessary
to remove CBA-MTMK battery adapter.
Remove the screws (Ref. to fi g. 7 and 7a)
and slide the adapter out.
CBA-MTMK
FIG. 7a