Table of Contents
Advertisement
H8S, H8SX Family E10A-USB Emulator
Table 2.7 Items in [External Flash memory setting] Dialog Box (cont)
No.
Item
9
Writing module address
10
Access size
11
Top address
12
End address
13
Bus width
14
Erasing time
15
Block count
16
Top address of block
17
Remarks
Note: Define in accord with the region of memory on the individual device.
R20UT0271EJ0100 Rev. 1.00
May 13, 2011
Section 2 Specifications of the Emulator's Software
Description
Entry address of the write module
Select the unit of accesses for transfer of the programs.
8bits(Byte): Bytes
16bits(Word): Words
32bits(Long): Longwords
Top address of the flash memory
End address of the flash memory*
Select the unit of accesses to the flash memory.
8bits(Byte): Bytes
16bits(Word): Words
32bits(Long): Longwords
Waiting time for erasure (in seconds)
(Specification of a decimal or hexadecimal value is
recommended.)
Number of blocks in the flash memory
(Specification of a decimal or hexadecimal value is
recommended. Up to 1024 blocks can be specified.)
Define the start addresses of all blocks. If the flash
memory has D'10 blocks, the definition will be as shown
below. Press the Return key between the definitions for
each of the blocks.
Example:
H'0
H'1000
H'2000
H'3000
H'4000
H'5000
H'6000
H'7000
H'8000
H'9000
Use for writing a text. Contents of data that has been set
can be entered. If not specified, setting is not needed.
Page 18 of 20
Advertisement
Table of Contents
