OHAUS Ranger Count 3000 Instruction Manual page 3

EN-2
SETUP
After the main platform is connected to the 2
menu item in the SETUP menu (see menu structure below).
Then set the CAP2 and Grad2 in the SETUP menu and do a calibration. Press and hold the
key to switch between the main platform and the secondary platform.
CAL
Zero2
Span1
Span2
Lin1
Lin2
GEO
End
Note: Make sure to perform a calibration of the scale before using the 2
sure the weighing unit is in kg or lb when using high capacity platform. (If display shows error8.6,
long press [Units] key to switch unit to kg or lb.)
COMPLIANCE
This accessory has been tested and complies with the approvals listed in the applicable
Instruction Manual.
Disposal
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
SETUP
Reset
D.Scale
Cap2
Grad2
Pwr. Un
Zero
A.Opt
A.Tare
Bp.Opt
Bp.Sig
Bp.Key
Accum
End
In conformance with the European Directive 2002/96 EC on Waste Electrical and
Electronic Equipment (WEEE) this device may not be disposed of in domestic waste.
This also applies to countries outside the EU, per their specific requirements. Please
dispose of this product in accordance with local regulations at the collecting point
specified for electrical and electronic equipment. If you have any questions, please
contact the responsible authority or the distributor from which you purchased this
device.
Should this device be passed on to other parties (for private or professional use), the
content of this regulation must also be related.
Thank you for your contribution to environmental protection.
TestEquipmentDepot.com
weighing platform, switch on the Dual Scale (D.Scale)
nd
2 Scale Interface
nd
nd weighing platform. Make