Program Settings (Dip Switch) - Chamberlain LiftMaster HS670 Owner's Manual

PROGRAM SETTINGS (DIP SWITCH S1)
NOTE: For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position.
TIMER TO CLOSE ENABLE
This switch (S1-1) enables the auto close timer. The timer to
close feature works in conjunction with the potentiometer
located on the board.
TIMER TO CLOSE
ENABLED
S1
ON
ON
1 2 3 4
SLIDE/SWING
This switch (S1-2) selects slide or swing gate operation, in
order to optimize gate behavior for specific application.
SL = Slide, 1 second delay
SW = Swing, 1.5 second delay
RIGHT/LEFT OPERATION
This switch (S1-3) selects the gate opening direction, to the left
or to the right. Right/Left operation is determined from the
inside of fence looking out.
"SAVE" SWITCH
This switch (S1-4) stores all settings into memory and locks out
changes. NOTE: For any programming changes to take effect this
switch must be in OFF position. When switch is ON, no settings
can be changed.
PROGRAM SETTINGS (DIP SWITCH S2)
NOTE: For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position.
MAGLOCK ENABLE
This switch enables the Maglock feature. On an open command
there will be a half second delay after the maglock relay is
released before the motor starts.
WARNING ENABLE
This switch enables the gate "in motion" alarm feature. The
alarm will beep 3 seconds prior to movement and throughout
movement.
P R O G R A M M I N G
TIMER TO CLOSE
DISABLED
S1
ON
ON
1 2 3 4
TIMER TO CLOSE
SWING GATE
ON
1 2 3 4
RIGHT HAND
ON
ON
1 2 3 4
LOCKED
ON APEMs
1 2 3 4
MAGLOCK ENABLED
S2
ON
ON
1 2 3 4
WARNING ENABLED
S2
ON
ON
1 2 3 4
17
Max = 180 sec
SLIDE GATE
S1 S1
ON
ON ON
1 2 3 4
LEFT HAND
S1
S1
ON
ON
1 2 3 4
UNLOCKED
S1 S1
ON
ON
ON
1 2 3 4
MAGLOCK DISABLED
S2
ON
ON
1 2 3 4
WARNING DISABLED
S2
ON
ON
1 2 3 4
Min = 0 sec