Canon EOS 250D Advanced User's Manual page 243

Do not point the camera toward an intense light source, such as the sun or an
z
intense artificial light source. Doing so may damage the image sensor or the
camera's internal components.
Time-lapse movies cannot be recorded when the camera is connected to a
z
computer with the interface cable, or when an HDMI cable is connected.
Movie Servo AF will not function.
z
Do not zoom the lens during time-lapse movie shooting. Zooming the lens
z
may cause the image to be out of focus, the exposure to change, or the lens
aberration correction not to function properly.
During time-lapse movie shooting, auto power off will not take effect. Also,
z
you cannot adjust the shooting function and menu function settings, play back
images, etc.
Sound is not recorded for time-lapse movies.
z
With [Interval] set to less than 3 sec. and [Auto exposure] set to [Each
z
frame], if the brightness differs greatly from the preceding shot, the camera
may not shoot at the set interval.
Movie digital IS is not available.
z
If the time it takes to record to the card exceeds the interval between shots
z
due to the shooting functions set or card performance, some of the shots may
not be taken with the set intervals.
If you connect the camera to a computer with an interface cable and use EOS
z
Utility (EOS software), set [z: Time-lapse movie] to [Disable]. If an option
other than [Disable] is selected, the camera cannot communicate with the
computer.
During time-lapse movie shooting, the lens's Image Stabilizer will not operate.
z
Time-lapse movie shooting ends if the power switch is set to <2>, for
z
example, and the setting is changed to [Disable].
Even if a flash is used, it will not fire.
z
The following operations cancel standby for time-lapse movie recording and
z
switch the setting to [Disable].
Selecting either [Clean nowf] under [5: Sensor cleaning] or selecting
-
[Clear all camera settings] under [5: Clear settings].
- Turning the Mode Dial.
If you start time-lapse movie shooting while the white <s> temperature
z
warning (= 215) is displayed, the image quality of the time-lapse movie may
decline. It is recommended that you start time-lapse movie shooting after the
white <s> disappears (camera's internal temperature decreases).
243