Resetting Thermal Protection; Cleaning And Sanitizing Instructions - Waring Torq 2.0 TBB160 Instructions Manual

9. Wash and dry the container after each use. See Cleaning
and Sanitizing Instructions.
10. Unplug to turn off all power to blender.

RESETTING THERMAL PROTECTION

• Your blender is equipped with a manual reset switch to protect
the motor from overheating.
• If your blender stops running under heavy use, or if the LED
light starts to blink much more rapidly than usual during normal
blending, press the power switch to OFF and unplug the power
cord. Empty the blender container of all its contents and allow
approximately 5 to 10 minutes for the motor to cool down.
• Plug the power cord back into the outlet and continue
blending.
• If your blender does not function properly following this
procedure, discontinue use and contact a certified Waring
Customer Service Center.

CLEANING AND SANITIZING INSTRUCTIONS

THE CONTAINER MUST BE CLEANED AND DRIED AFTER EACH
USE OF THE BLENDER ACCORDING TO THE FOLLOWING
INSTRUCTIONS.
FAILURE TO DO SO MAY ALLOW RESIDUE OF PROCESSED
MATERIAL TO COLLECT ON THE INTERNAL SEALS OF THE
BLADE ASSEMBLY, RENDERING THEM INEFFECTIVE.
• Wash, rinse, sanitize and dry container prior to initial use and
whenever it will not be used again within a period of 1 hour.
• Wash and rinse container after each use.
• Clean and sanitize motor base prior to initial use and after each
use.
• Washing solutions based on non-sudsing detergents and
chlorine-based sanitizing solutions having a minimum chlorine
concentration of 100 PPM are recommended.
The following washing, rinsing, and sanitizing solutions, or their
equivalents, may be used.
9