Table of Contents
Advertisement
When this happens
這種情況下
Automatic Ice Making is not properly performed.
Ice tray frame cannot be
drawn
製冰盤的框子拉不出來
Refrigerator does not cool
Refrigerator does not
cool
Frost and/or dew occur
,
Ice cream becomes soft
.
不冷
結霜•結露
冰淇淋太軟
__R-SF6800Z.indd
47
Please check. This is the cause.
請檢查一下。是這原因嗎？
Is "Large" or "Normal" display of Ice Making turned on?
●
→ Ice tray frame cannot be drawn while making ice with the Automatic Ice Maker.Turn
on the "Stop" display.
If the "Stop" display starts flashing, wait about 20 seconds until the display is turned
on and draw the ice tray frame. (
製冰「大顆」・「標準」 顯示亮著燈嗎？
●
→ 自動製冰機正在製冰時拉不出來。請使「停止」顯示亮燈。
「停止」顯示剛開始閃爍時，請等約20秒、「停止」顯示亮燈後再拉出。（ 42 頁）
不冷
Check the storage state of food
Does any food or package caught in the door prevent the door
●
from closing completely?
→ Check that there is not any space between the door seal and its
contact surface with the door closed.
Is food squeezed in? or Is a large amount of food put in at a time?
●
→ Make sure that any food does not protrude beyond the storage
height limit of each compartment, and do not store the amount of
food that may prevent the door from opening and closing.
→ Allow clearance between each food in each compartment.
Are Upper Freezer Case and Slimline Slide Case installed correctly?
●
→ Install them correctly. (
Pg. 39)
Check the installation state
Refrigerator may not fully cool according to the place where it was installed, the clearance around
●
it and the surrounding conditions. Check whether it has been installed correctly. (
Check the temperature setting
Refrigerator may not cool fully when the temperature setting is "MIN".
●
→ Switch the temperature setting of the compartment where it does not fully cools to
"MID" or "MAX".(
Pg. 19)
Does the temperature around the refrigerator become high due to a seasonal factor
●
(ex:using in summer)?
→ Switch the temperature setting of the compartment where it does not fully cools to "MAX".
Check the usage of the refrigerator
Temperature in the refrigerator rises little by little while its door is open. If
●
opening/closing the door frequently or leaving the door open for a long time,
temperature cannot easily lower.
→ Reduce the number of times of opening and closing the door or open/close the door quickly.
確認食物的儲放狀況
食品或袋子被挾著、門關緊了嗎？
●
→ 請在關著門的狀態檢查一下密封墊處有無縫隙。
●
是否過分塞堵食品、是否一次放入了大量的食物呢？
→ 請遵守可容納食品的高度，儲放量不要影響門的開關。
→ 食品之間請離開間隙儲放。
上層冷凍盒、薄滑動盒裝好了嗎？
●
→ 請正確安裝好。（ 39 頁）
(Continue)
自動製冰不正常
Pg. 42)
密封襯墊之間有間隙的狀態
（繼續）
(Continue)（繼續）
There is a space
between the door
seal and its
contact surface.
Pg. 12)
遇
到
困
難
的
時
候
︵
繼
續
︶
2009/10/26
11:17:13
Advertisement
Table of Contents
