Hitachi R-SF6800Z Instructions For Use Manual page 38

Table of Contents

Advertisement

HOW TO REMOVE PARTS
HOW TO REMOVE PARTS
Refrigerator Compartment
Descendible case
Fixed shelf
固定層 架
Draw the shelf, and pull off the two forks
on the lower right and remove it.
往身前拉出來、將右下2個地方的鈎脫開卸除。
Height adjustable shelf Lower shelf
1
Slightly lift up the back of the shelf and draw it.
稍微提一下層架的裏頭,往身前拉出
When installing the shelf, slide it until it reaches to the interior
wall, then slightly lift up the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Caution
● Door may damage if drawing the shelf without lifting it.
Vacuum compartment
Slightly lift up the front side of the vacuum compartment case, release the case from
the catch on the door and pull it towards you.
輕輕抬起真空室盒前部,將盒從箱門上的掛鉤上放開,往身前把盒拉出。(
Caution
Do not wash the vitamin cassette with water.
Height adjustable pockets
Remove by lifting while holding the knobs on both sides with
both hands. To attach, push down with both hands.
兩手握住兩側的旋鈕往上抬起予以卸除。
安裝時則用兩手往下推。

__R-SF6800Z.indd
38
冷藏室
下移式便取盒
Draw the Descendible Case while lifting it, and remove it from the rail.
When installing it, align the axis of the case with the groove of the rail and
push it in.
一邊提起一邊從箱軌上拉出來卸下。
安裝時,將層架的軸沿著箱軌的溝推進去。
可調式層架 ・ 低層架
真空室 (X System 真空チルド)
(
Pg. 23)
注 意 事 項
請勿用水清洗維生素盒。
可調式置物架
卸除組件的方法
卸除組件的方法
卸除組件的方法
Name and installation place of parts. (
部件的名稱與安裝位置(
Reversible shelf
翻轉式 層架
Slightly lift up and pull out.
稍微向上拉出。
2
Raise the shelf as shown in figure, and turn it and remove it.
如圖,將層架竪起後翻轉、卸除。
安裝時,把層架插放到最裏面之後,稍微提一下層架的
裏頭推進去。
(將層架的鈎扣掛在最裏面的配件上)
注 意 事 項
●直接把層架拉出會有可能損傷箱門。
頁)
23
Fixed door pockets
Insert the door pocket fully to the end when installing it.
安裝時要徹底插入到最裏面。
Pg. 16)
16 頁)
固定容器置物架
2009/10/26
11:17:12
1
To
Se
1
3
W
I
U

Advertisement

Table of Contents
loading

Table of Contents