Table of Contents
Advertisement
installation
GLASS CRYSTALS AND OPTIONAL STONES INSTALLATION ON BURNER AND FIREBOX FLOOR
Spread the glass crystals or stones evenly over the burner. Ensure the crystals (or stones) do not overlap too much as this will effect the flame pattern.
IMPORTANT NOTE:
Only the supplied approved glass crystals and stones are to be used with these fireplaces. Use of any other type of glass crystals or stones can alter the
unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
When using ceramic spa/volcanic stones ensure required glass crystals/beads are used as a base. DO NOT overstack Ceramic spa stones or Volcanic stones
on the burner or in the pilot area.
Unit
*Glass Crystals
HZ33CE
4 lb
NOTE: * Glass Crystals are available in 1lb and 5lb bags.
** Spa stone package contains 70 stones
3) Work Crystals from back to front
edge of Firebox Floor
Glass Crystals shown on Burner and Firebox Floor
OPTIONAL SPA STONES INSTALLATION (AROUND BURNER)
NOTE:
48 |
®
Regency Horizon
HZ33CE-11 Gas Fireplace
BURNER PACKAGES
**Spa Stones
4 lb glass + 70 spa stones 4 lb glass + 30 stones
1) Start installing Crystals on back of
Burner and Firebox Floor
4) Spread Crystals evenly over the
burner and firebox base
Spa/Volcanic stones are NOT to be placed anywhere on the burner tube or Pilot assembly area.
Volcanic Stones
NOTE: Correct final glass installation of Crystals shown
in step 4 and 5.
The Burner and Firebox Floor should not be visible
when the flame is out.
Beads
5lbs
2) Distribute Crystals evenly towards
front of Burner and Firebox Floor
5) Ensure Crystals DO NOT block the
front of the pilot hood and flame to
light the burner
Advertisement
Table of Contents
