Table of Contents
Advertisement
Note:
Cable hole is required, when adopting the ceiling
outlet to route cables.
3. Loosen the screws with a hex wrench (supplied) to
remove the bubble.
4. Fix the mounting base on the ceiling with supplied
screws.
5. Route the cables through the cable hole, or the side
opening.
6. Connect the corresponding cables, such as power
cord, and video cable.
7. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle
Figure 2-19 Type I Camera 2-Axis Adjustment
1). Loosen the tilt adjusting screw to adjust the tilt
position [0° to 75°].
2). Hold the black liner to adjust the pan position [0°
to 355°].
3). Hold the camera body to adjust the rotation
position [0° to 355°].
8. Reinstall the bubble, and tighten the screws.
Figure 2-17 Remove the Bubble
Figure 2-18 Fix the Mounting Base
0° to 75°
Figure 2-20 Bubble Reinstallation
0° to 355°
Adjusting Screw
0° to 355°
Advertisement
Table of Contents
