HIKVISION DS-2CE78U1T-IT1F User Manual page 10

For cement wall/ceiling, expansion bolts are

required to fix the camera. For wooden wall/ceiling,
self-tapping screws are required.
6. Route the cables through the cable hole, or the side
opening.
7. Secure the camera on the mounting base.
1） pull out the clip plate, and then to combine the
camera with the mounting base.
2） Push the clip plate in, and secure the camera by
tightening the screw.
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
1). Hold the camera body and rotate the enclosure to
adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust the
tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
Note:
Loose the screw on the mounting base before
adjusting the monitoring angle.
2.4 Ceiling Mounting of Type IV Camera
Steps:
1. Paste the dill template to the ceiling.
2. Drill the screw holes and cable hole (optional) in the
ceiling according to the drill template.
Figure 2-14 Secure the Camera
Figure 2-15 3-axis Adjustment
1
Drill Template
Hole A: for cables routed through the ceiling
screw hole 1: for Mounting Base
Figure 2-16 Drill Template
Screw
Hole
1
Cable
Hole
A
1