Mirage IAEH121A Owner's Manual page 33

Installation of indoor unit
2. Make the power connection wire
go through the cable-cross hole at
the back of indoor unit and then pull
it out from the front side.
3. Remove the wire clip; connect the
power connection wire to the wiring
terminal according to the color;
tighten the screw and then fix the
power connection wire with wire clip.
Note: the wiring board is for reference only,please refer to the actual one.
4. Put wiring cover back and then
tighten the screw.
5. Close the panel
Note:
• All wires of indoor unit and outdoor unit should be connected by a
professional.
• If the length of power connection wire is insufficient, please contact the
supplier for a new one. Avoid extending the wire by yourself.
• For the air conditioner with plug, the plug should be reachable after
finishing installation.
• For the air conditioner without plug, an air switch must be installed in the
line. The air switch should be all-pole parting and the contact parting
distance should be more than 3mm.
30