Mirage IAEH121A Owner's Manual page 15

Introduction for buttons on remote controller screen
• It's defaulted to display set temperature when turning on the unit.There is
no display in the remote controller.
• Only for the models whose indoor unit has dual-8 display.
• When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically
turn to display set temperature after thee or five seconds.
I FEEL button
9
Press this button to start I FEEL function and "
remote controller. After this function is set, the remote controller will send the
detected ambient temperature to the controller and the unit will automatically
adjust the indoor temperature according to the detected temperature. Press
this button again to close I FEEL function and "
• Please put the remote controller near user when this function is set. Do not
put the remote controller near the object of high temperature or low tem-
perature in order to avoid detecting inaccurate ambient temperature. When
I FEEL function is turned on, the remote controller should be put within the
area where indoor unit can receive the signal sent by the remote controller.
LIGHT button
10
Press this button to turn off display light on indoor unit. "
controller disappears. Press this button again to turn on display light. "
icon is displayed.
CLOCK button
11
Press this button to set clock time. "
Press "▲" or "▼" button within 5s to set clock time. Each pressing of "▲" or
"▼" button, clock time will increase or decrease 1 minute. If hold "▲" or "▼"
button, 2s later, time will change quickly. Release this button when reaching
your required time.
Press "CLOCK" button to confirm the time. "
Note:
• Clock time adopts 24-hour mode.
• The interval between two operation can't exceeds 5s. Otherwise, remote
controller will quit setting status. Operation for TIMER ON/TIMER OFF is the
same.
TIMER ON / TIMER OFF button
12
• TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button,
" " icon disappears and the word "ON" on remote controller blinks. Press
"▲" or "▼" button to adjust TIMER ON setting. After each pressing "▲" or
"▼" button, TIMER ON setting will increase or decrease 1min. Hold "▲" or
"▼" button, 2s later, the time will change quickly until reaching your required
time.
" will be displayed on the
" will disappear.
" icon on remote controller will blink.
" icon stops blinking.
" icon on remote
"
12