Operation Guide; Replacement Of Batteries In Remote Controller - Mirage IAEH121A Owner's Manual

Operation guide

1. After putting through the power, press "ON/OFF" button on remote control-
ler to turn on the air conditioner.
2. Press "MODE" button to select your required mode: AUTO, COOL, DRY,
FAN, HEAT.
3. Press "▲" or "▼" button to set your required temperature. (Temperature
can't be adjusted under auto mode).
4. Press "FAN" button to set your required fan speed: auto, low, medium and
high speed.
5. Press "SWING" button to select fan blowing angle.

Replacement of batteries in remote controller

1. Press the back side of remote
controller marked with " " as shown in
the fig, and then push out the cover of
battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry
batteries, and make sure the position
of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
NOTICE
• During operation, point the remote control signal sender at the receiving
window on indoor unit.
•The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
• Signal may be interfered easily in the room where there is fluorescent
lamp or wireless telephone; remote controller should be close to indoor
unit during operation.
• Replace new batteries of the same model when replacement is required.
• When you don't use remote controller for a long time, please take out the
batteries.
• If the display on remote controller is fuzzy or there's no display, please
replace batteries.
signal sender battery
reinstall
remove
Cover of battery box
15