Mirage IAEH121A Owner's Manual page 13

Introduction for buttons on remote controller screen
When selecting heating mode, the air conditioner operates under heat mode.
Heat indicator on indoor unit is ON. Press "▲" or "▼" button to adjust set
temperature. Press "FAN" button to adjust fan speed. Press "SWING" button
to adjust fan blowing angle. (Cooling only unit won't receive heating mode
signal. If setting heat mode with remote controller, press ON/OFF button
can't start up the unit).
Note:
For preventing cold air, after starting up heating mode, indoor unit will delay
1~5 minutes to blow air (actual delay time is depend on indoor ambient
temperature).
Set temperature range from remote controller: 61~86°F; Fan speed: auto,
low speed, medium speed, high speed.
FAN button
3
Pressing this button can set fan speed circularly as: auto (AUTO),
low( ), medium (
Note:
• Under AUTO speed, air conditioner will select proper fan speed
automatically according to ex-factory setting.
• Fan speed under dry mode is low speed.
4 SWING button
Press this button can select up&down swing angle. Fan blow angle can be
selected circularly as below:
(horizontal louvers stops
at current position)
• When selecting "
tal louver will automatically swing up & down at maximum angle.
• When selecting "
fixed position. Horizontal louver will stop at the fixed position.
• When selecting "
Horizontal louver will send air at the fixed angle.
• Hold " " button above 2s to set your required swing angle. When reach-
ing your required angle, release the button.
Note:
" "may not be available. When air conditioner receives this signal,
the air conditioner will blow fan automatically.
), high( ).
Auto
no display
", air conditioner is blowing fan automatically. Horizon-
" air conditioner is blowing fan at fixed angle.
" air conditioner is blowing fan at
10