Installing The Backguard - Bertazzoni PRO366GASAR Installation, Use & Care Manual

INSTALLING THE BACKGUARD
The backguard must be installed prior to
operation of the appliance for appropriate
ventilation of the oven compartment.
The supplied backguard is a 2‐part assembly. The
box also contains a set of metal screws for
securing the backguard to the worktop.
Disassemble the backguard and position the front
part on the worktop. Align the screw holes with
the corresponding holes at the back of the
worktop.
If the holes are not aligned, partially loosen the
brackets att the back of the worktop as shown
below.
Install the front part of the backguard by
tightening the 2 central screws from the top and
2 lateral screws from the bottom.
Position the back part of the backguard and
secure it to the worktop tightening 4 screws from
the bottom.
Connect the back and front part of the upstand.
Check for tight assembly.
9