Controlnode - BMPRO J35B-L Owner's Manual

CONTROLNODE

1
PAIRING BUTTON
q
Button to enable Bluetooth pairing between the ControlNode and the JHub App
on your own personal mobile device or JHub Tablet.
LED STATUS INDICATOR
w
Indicates the operational/pairing status of the ControlNode.
Operational Status
ControlNode is ready to pair
ControlNode memory is full,
cannot pair to any new devices
Clearing ControlNode memory*
Table 5: ControlNode Operational Status and LED Flash Codes
*After memory has been cleared, the ControlNode LED Status Indicator will flash green.
CONTROLNODE SERIAL NUMBER
e
Required to choose the correct device when pairing the ControlNode to the JHub
App on your own personal mobile device or JHub Tablet.
Figure 2: The ControlNode
2
Flashing Status Note
Green Flash 30 sec
Orange Flash 1 sec To pair to a new mobile device, clear
Red Flash 1 sec
3
the memory of the ControlNode
Memory will only be cleared if the
user presses and holds the Pairing
Button for 10 seconds.
14