Advertisement
Step 28. Position the Cables and Wires to Prevent Pinching
On the top side of the PNA, carefully position the grey flex cables so they can't be pinched between
the covers and the rails.
On the bottom side of the PNA, carefully fold or push down the ribbon cables and wires so they
can't be pinched between the hardware and the outer cover. Ribbon cables and wires must never
be positioned on top of hardware.
Step 29.Reinstall the Inner Cover
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the PDF Service Guide
Step 30.Reinstall the Outer Cover
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the PDF Service Guide
Step 31.Install the Cable Guard
Push the cable guard over the new front jumper cables until its cushioning material touches the
front panel of the PNA.
Step 32.Remove Option 224 and Option 219 Licenses
Procedure Requirements
— The analyzer must be powered up and operating to perform this procedure.
— The Network Analyzer program must be running.
— A keyboard and mouse must be connected to the network analyzer.
Option 224 and Option 219 License Removal Procedure
1. To start the option enable utility, press UTILITY
An option enable dialog box will appear.
2. Click the arrow in the Select Desired Option box. A list of available options will appear.
3. In the Select Desired Option list, click 224.
4. Click Remove.
5. Click OK to confirm that you want to remove the license for the selected option.
6. Click No in answer to the displayed question in the Restart Analyzer? box.
7. Click the arrow in the Select Desired Option box. A list of available options will appear.
8. In the Select Desired Option list, click 219.
9. Click Remove.
10.Click OK to confirm that you want to remove the license for the selected option.
Installation Note N5242-90017
Installation Procedure for the Upgrade
, then
Service
System
1
.
1
.
, then
Option Enable
38
.
Advertisement
