Table of Contents
Advertisement
Quick Links
TECHNICAL INFORMATION:
Rated Power:
Heating Element:
Reflector:
Dimensions:
Remote control:
Warm-up time:
Useful wavelength range:
Weight:
Protection:
ELECTRICAL EQUIPMENT:
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
IMPORTANT NOTICE TO PURCHASER:
Before utilizing the product, you should determine the suitability of the product for its intended use. HERSCHEL INFRARED LTD
expressly disclaims the implied warranties and conditions of merchantability and fitness for a particular purpose. In no case shall
HERSCHEL INFRARED LTD be liable under any legal theory, including but not limited to contract or strict liability, for any direct,
indirect special, incidental or consequential damages resulting from product use.
The product complies with Safety Standards EN60335-2-30, RoHS and EMC EN 50336 and EN 62233. These cover the
essential requirements of EEC Directives 2006/42/EC, 2011/65/EC and 2004/108/EC.
Original instructions covering CALIFORNIA 2000R produced 052017 onwards.
HERSCHEL CALIFORNIA 2000R
Wall-mounted Infrared Heaters
INSTALLATION & OPERATING INSTRUCTIONS
2000W at 220-240V
Ultra long life Carbon heating lamp (10,000 hours)
Mirror Aluminium (98% reflection preventing rearward heat loss)
780 x 125 x135mm
2 power levels (50% power increments) & 9 hour time (9x1 hour increments)
Wall or Stand (available separately)
5-10 seconds
2 - 5μm
3kg
2 Years (excludes lamp & remote control)
IP65
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Herschel FN834
Summary of Contents for Herschel FN834
- Page 1 In no case shall HERSCHEL INFRARED LTD be liable under any legal theory, including but not limited to contract or strict liability, for any direct, indirect special, incidental or consequential damages resulting from product use.
- Page 2 Switches and other controls cannot be touched by a person in a bath or shower. If in doubt, do not install. Herschel Infrared Ltd shall not be liable for any loss, damage or injury caused or resulting from inadequate fitting or incorrect placement of heaters close to water sources.
- Page 3 For permanent installation (i.e. not using a stand), the Herschel CALIFORNIA must be located in a position to allow proper and efficient use but one that ensures hot parts are not touched accidentally. The recommended installation height of the CALIFORNIA is 2.4m to 3.5m (95”-138”) from the floor.
- Page 4 Diagram 2: Bracket Assembly Diagram 3: Wall Mounting Position Diagram 4: Installation using a stand: The CALIFORNIA may be installed on its own stand (available separately). Installation is easy using the brackets supplied following the diagrams below. The heater incorporates a tip-over function which will cut the power if the unit detects an angle greater than 45°.
- Page 5 10 – 20 minutes to dry the unit and prevent staining. The lamp used in the Herschel CALIFORNIA is Ultra long life (10,000 hours). Changing the lamp should only be carried out by suitably qualified personnel using the instructions available on Herschel’s website.
- Page 6 The CALIFORNIA is not recommended for use indoors to reach and maintain a defined temperature level in an enclosed space. Herschel is not responsible for any breach of the legislation where the CALIFORNIA is used indoors in such a way as to put it within scope of the EcoDesign Directive.
Need help?
Do you have a question about the FN834 and is the answer not in the manual?
Questions and answers