Advertisement
Quick Links
PS636 Series
Gas
Domestic & Std Export
ENGLISH
PS636 Series Gas Ovens
Model:
•
PS636G Gas
OWNER'S OPERATING AND
INSTALLATION MANUAL
for domestic and standard export ovens
©2014 Middleby Marshall Inc.
is a registered trademark of Middleby Marshall, Inc. All rights reserved.
Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • (847)741-3300 • FAX (847)741-4406
Combinations:
•
Single Oven
•
Double Oven (Two-Stack)
•
Triple Oven (Three-Stack)
P/N 66639
December 2014 Rev. E
Advertisement
Related Manuals for Middleby Marshall PS636G
Summary of Contents for Middleby Marshall PS636G
- Page 1 INSTALLATION MANUAL for domestic and standard export ovens ©2014 Middleby Marshall Inc. is a registered trademark of Middleby Marshall, Inc. All rights reserved. Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • (847)741-3300 • FAX (847)741-4406...
-
Page 6: Oven Specifications
Voltage Voltage Draw 208-240VAC 208-240VAC 50/60Hz 4-3 Amp 2 Pole 3 Wire (2 hot, 1 gd) Table 1-4: Gas orifice and pressure specifications for PS636G gas ovens Main Orifice I.D. Supply (Inlet) Orifice (Manifold) Bypass Type PS745G Pressure Pressure Pressure Natural 0.094 (2.375120mm) -
Page 7: Section 2 - Installation
SECTION 2 – INSTALLATION WARNING – After any conversions, readjustments, or service work on the oven: • Perform a gas leak test. • Test for proper combustion and gas supply. • Test for correct air supply, particularly to the • Check that the ventilation system is in operation. burner blower. - Page 8 PS636 24” OVEN INSTALLATION REQUIRED KITS AND EQUIPMENT PS636 PS636 PS636 PS636 Gas Oven Single Oven Double Oven Triple Oven Installation Option Base w/ Option Base w/ Option Base w/ Type Of Installation 15” Legs, 15” Legs, 15” Legs, Casters & Top Casters &...
-
Page 9: Ventilation System
III. VENTILATION SYSTEM B. Recommendations NOTE THAT THE HOOD DIMENSIONS SHOWN IN FIGURE 2-5 ARE RECOMMENDATIONS ONLY. IMPORTANT LOCAL, NATIONAL AND INTERNATIONAL CODES MUST BE FOLLOWED WHEN INSTALLING THE Where national or local codes re- VENTILATION SYSTEM. ANY APPLICABLE CODES SUPERSEDE THE RECOMMENDATIONS SHOWN IN THIS MANUAL. - Page 10 IV. ASSEMBLY Figure 2-6. Leg extension and casters installation A. Top Panel and Base Pad Assembly Install the four leg extensions onto the base pad using the 3/8″-16 × 1″ screws, 3/8″ flat washers, and 3/8″ lockwashers supplied in the Base Pad Kit. See sion face OUTWARDS.
- Page 11 Gas oven cavities be stacked BY AUTHORIZED PERSO- NEL. front casters. Figure 2-10. Top panel installation Contact your Middleby Marshall Authorized Service Agent for complete stacking instructions. Stack an oven cavity on top of the lower oven. Check #10-32 × 2-1/2″...
- Page 12 D. Conveyor Installation Figure 2-13. Conveyor placement Unfold the conveyor as shown in Figure 2-12. Then, begin to slide the conveyor into the end of the oven. The conveyor can only be installed from the end of the oven with the drive motor. Crumb tray support Continue moving the conveyor into the oven until the frame...
-
Page 22: Section 4 - Maintenance
NOTE ANY replacement parts that require access to the interior of the oven may ONLY be replaced by a Middleby Marshall Autho- rized Service Agent. It is also strongly recommended that the 3-Month Maintenance and 6-Month Maintenance procedures in this section be performed ONLY by a Middleby Marshall Authorized Service Agent. -
Page 27: Section 5 - Wiring Diagram
SECTION 5 - WIRING DIAGRAM... - Page 28 NOTES...
- Page 29 NOTES...
- Page 30 NOTICE During the warranty period, ALL parts replacement and servicing should be performed by your Middleby Marshall Authorized Service Agent. Service that is performed by par- ties other than your Middleby Marshall Authorized Service Agent may void your war- ranty.
Need help?
Do you have a question about the PS636G and is the answer not in the manual?
Questions and answers