Table of Contents
Advertisement
appenDICes
projector Installation notice
‡
Place the projector in a horizontal position
±
The tilt angle of the projector should not exceed 5 degrees, nor should the projector be in-
stalled in any way other than the desktop and ceiling mount, otherwise lamp life could decrease
dramatically, and may lead to other unpredictable damages.
Ceiling Mount Installation
1.
To prevent damage to your projector, please use the Optoma ceiling mount.
2.
If you wish to use a third party ceiling mount kit, please ensure the screws used to attached a mount to
the projector met the following specifications:
±
Screw type: M4
±
Maximum screw length: 11mm
±
Minimum screw length: 9mm
notee:
Please note that damage resulting from incorrect installation will invalidate the warranty.
Warning:
‡
If you buy ceiling mount from other company, please be sure to use the correct screw size. Screw size
will be different on different mounts. It depends on the plate thickness.
‡
Be sure to keep at least 10cm gap between the ceiling and the bottom of the projector.
‡
Avoid installing the projector near a heat source.
76
English
Advertisement
Table of Contents
Need help?
Do you have a question about the EH460ST and is the answer not in the manual?