Table of Contents
Advertisement
Removing the System Memory (RAM)
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDRIII (DDR3) Up to 1066/1333 MHz. The main memory can be expanded up to 8GB. The SO-DIMM modules sup-
ported are 1024MB and 2048MB DDRIII Modules. The total memory size is automatically detected by the POST rou-
tine once you turn on your computer.
Memory Upgrade Process
1. Turn off the computer, turn it over and remove the battery
2. Remove screws
-
from the component bay cover
1
4
3. Carefully (a fan and cable are attached to the under side of the cover) lift up the bay cover.
4. Carefully disconnect the fan cable
to an angle of around 30° angle).
5. The RAM modules will be visible at point
a.
2
3
(page 2 -
(Figure
5a).
, and remove the cover
(note that you need to raise the bottom cover up
5
6
on the mainboard
(Figure
7
b.
1
4
5).
5b).
7
6
5
6
10
Removing the System Memory (RAM) 2 - 9
Disassembly
Figure 5
RAM Module
Removal
a. Remove the screws.
b. The RAM modules will
be visible at point
7
on the mainboard.
6. Component Bay Cov-
er
• 4 Screws
Advertisement
Table of Contents
