Table of Contents
Advertisement
Disassembly
Removing the Keyboard/CCD
Figure 8
Keyboard / CCD
1. Turn off the computer, and remove the battery
Removal
2. Remove screws
a. Remove screws from the
to unsnap the LED cover module (use the eject pin tool provided to do this
7
bottom of the computer.
3. Turn the computer over, unsnap up the LED cover module
b. Turn the computer over,
unsnap up the LED cov-
4. Remove screws
er module from the cent-
5. Carefully lift the keyboard
er of the computer.
board ribbon cable
c. Remove screws
from
pins
the keyboard.
6. Carefully lift up the keyboard
d. Carefully lift the key-
board up and disconnect
the keyboard ribbon ca-
a.
ble from the locking col-
lar socket by using a flat-
head screwdriver to pry
the locking collar pins
away from the base.
e. Remove the keyboard.
b.
c.
8. LED Cover Module
14. Keyboard
11 Screws
2 - 12 Removing the Keyboard/CCD
-
from the bottom of the computer (inside the battery compartment), and then press at point
1
6
-
from the keyboard
9
13
up, being careful not to bend the keyboard ribbon cable
14
from the locking collar socket
15
away from the base
(Figure
8d).
17
(Figure
14
7
1
2
6
5
4
8
9
10
11
12
13
(page 2 -
5) and the component bay cover
from the center of the computer
8
(Figure
8c).
by using a flat-head screwdriver to pry the locking collar
16
8e) off the computer.
d.
3
e.
14
Keyboard Tabs
(page 2 -
9).
Figure
8a).
(Figure
8b).
. Disconnect the key-
15
14
15
17
17
16
Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
four keyboard tabs at
the bottom
(Figure
8e)
at the bottom of the key-
board with the slots in
the case.
Advertisement
Table of Contents
