Rebooting The Se681 Wimax; Returning The Se681 Wimax To Factory Settings - SAGEMCOM SE681 WiMAX User Manual

Restarting and resetting the SE681 WiMAX

Rebooting the SE681 WiMAX

Briefly press the reset button (for less than 5 seconds). The configuration settings

will remain, the SE681 WiMAX will be restarted.
You can also restart the SE681 WiMAX via the user interface or by briefly cutting the
power supply.

Returning the SE681 WiMAX to factory settings

If you no longer have access to your SE681 WiMAX, you can also restore factory set-
tings with the reset button on the back of the device.
!
When the factory settings are restored, all personal settings are deleted.
Press and hold the reset button for more than 5 seconds.

The 4 RSSI LEDs will begin to flash green. The configuration settings are returned to
the factory settings and the SE681 WiMAX is restarted. This process takes about
25 seconds. The SE681 WiMAX will then automatically try to set up a connection to a
WiMAX network; depending on the connection quality, 0 to 4 RSSI LEDs will perma-
nently light up green.
Factory settings
After restoring the factory settings, your SE681 WiMAX will be in its original condition:
Proceed as follows to start operating your device again:

Menu
Basic Setup Wizard
Advanced Settings –
Administration –
System Password
18
Setting
Execute the Basic Setup Wizard to configure your device
and to establish a connection to the WiMAX network, see
"Basic Setup Wizard" on page 25.
Protect the configuration interface of your device with a
password, see "System password" on page 39.
If the device came from your provider with a preset sys-
tem password, this will now be valid again. Please check
the documents supplied by your provider.