Table of Contents
Advertisement
3.2. SETTING THE TIME
We start by first setting the Day and Time.
3.2.1 You can do this by Press & Holding the
Config/Prog. button until the following is shown.
Press & Release the Config/Prog button 7 times
again to advance through the 7
3.2.3 Now the hours start to flash. Press the "+"
and "-" button until you reach the correct time
(hour) and Press the OK/Mode button.
If the device is associated with a G-Control Hub, the adjustment of time is removed and the time in the G-Control Hub is
configured in the heater automatically.
3.3. PROGRAMMING
Select Auto Mode. Within this mode, the setpoint temperature varies according to the weekly schedule setup in the unit.
Default programming is: Comfort: 07:00 to 22:00 / Eco: 00:00 to 07:00 & 22:00 to 00:00.
3.3.1 Press & Hold the Config/Prog. button until the following is shown. The first segment will start to flash. By pressing the
OK/Mode button you can select whether you want a Frost setting
(19°C). Now press the "+" button to move to the next 1 hour time interval.
Note: These temperatures can be changed later without adjusting the times.
3.3.2 Once you've gone through all the time intervals for day 1, you will automatically start on day 2. Repeat the above steps
until you go through all 7 days. If you do not desire to modify the programming of a specific day, use the Config/Prog button
to advance to the next day programming. Once you have configured the desired programming, press Config/Prog button to
exit programming in the 7
th
3.3.3. After going through all the days the display will show and start to run the program and will flash between the set
temperature for the current day, time interval and the word Pro to indicate the heater is running the set program.
th
days programming.
day programme.
.
3.2.2. When pressing Config/Prog button when the 7
programming is displayed, you enter in the Time Setting. The day of the
week starts to flash. Using the "+" and "-" buttons select today's date.
1=Monday, 2=Tuesday, Etc. and Press the OK/Mode button.
3.2.4 Now the minutes start to flash. Press the "+" and "-" button until
you reach the correct time (minutes) and Press the OK/Mode button.
(5°C), Background setting
13
EN
th
day
(17°C) or Comfort setting
Advertisement
Table of Contents
