Louver Installation; Flueing Introduction; Installation Precautions; Safety Precautions For The Installer - Regency FireGenieFG39-LPG2 Owners & Installation Manual

Freestanding gas stove
Table of Contents

Advertisement

installation
LOUVER
INSTALLATION
1.
Attach the top & bottom louvres to the
side stove panel using 2 screws per
side.
8
FLUEING
INTRODUCTION
The DV Stove Horizontal Flue Kit and the Simp-
son Dura-Flue Room Sealed System Model
DV-GS flueing systems, in combination with the
Regency Room Sealed Freestanding Gas Stove,
FG39-NG2, and FG39-LPG2, have been tested
and listed as direct flue heater systems by AGA.
These units use the "balanced flue" technology
Co-Axial system. The inner liner flues products
of combustion to the outside while the outer pipe
draws outside combustion air into the combus-
tion chamber thereby eliminating the need to
use heated room air for combustion and losing
warm room air up the chimney.
Note: These flue pipes must not be con-
nected to any other appliance.
The gas appliance and flue system must be flued
directly to the outside of the building, and never
be attached to a chimney serving a separate solid
fuel or gas burning appliance. Each direct flue
gas appliance must use it's own separate flue
system. Common flue systems are prohibited.
IMPORTANT
Read all instructions carefully before starting
the installation. Failure to follow these instruc-
tions may create a fire or other safety hazard,
and will void the warranty. Be sure to check the
flueing and clearance to combustible require-
ments. Consult your local building codes before
beginning installation.
The location of the termination cap must conform
to the requirements in the Exterior Flue Termina-
tion Locations diagram on page 9.
INSTALLATION
PRECAUTIONS
These flueing systems are engineered products
that have been designed and tested for use with
the FG39-NG2, and FG39-LPG2. The warranty
will be voided and serious fire, health or other
safety hazards may result from any of the fol-
lowing actions:
1. Installation of any damaged Room Sealed
component
2. Unauthorised modification of the Room
Sealed System
3. Installation of any component part not manu-
factured or approved by Simpson Dura-Flue
or FPI Fireplace Products International Ltd.
4. Installation other than as instructed by
Simpson Dura-Flue and FPI
Products International Ltd.
Warning: Always maintain required
clearances (air spaces) to nearby
combustibles to prevent a fire
hazard. Do not fill air spaces with
insulation.
Be sure to check the flue termination clearance
requirements from decks, windows, soffits, gas
regulators, air supply inlets and public walkways
as specified in the Exterior Flue Terminal Loca-
tions on page 9 and in your local building codes.
The gas appliance and flue system must be
flued directly to the outside of the building,
and never be attached to a chimney serving
a separate solid fuel or gas-burning appli-
ance. Each direct flue gas appliance must use
it's own separate flue system. Common flue
systems are prohibited.
SAFETY
PRECAUTIONS FOR
THE INSTALLER
1.
Wear gloves and safety glasses for protec-
tion.
2.
Exercise extreme caution when using
ladders or on roof tops.
3.
Be aware of electrical wiring locations in
walls and ceilings.
FG39-2 Freestanding Gas Stove
Fireplace

Advertisement

Table of Contents
loading

This manual is also suitable for:

Firegenie fg39-ng2

Table of Contents