Installation; For The User - Bompani BO246SR/E Instructions For Use And Maintenance Manual

GB

INSTALLATION

The appliance must be installed by qualified staff working in
accordance with the regulations in force.
The appliance is produced to EN 60 335-1, EN 60 335-2 and is
of built-in type, meaning that it must be installed in accordance
with the producer's instructions.
The oven must be installed in a unit having materials (varnishes,
finishes, glues, etc.) resistant to a temperature of at least 100°C.
The dimensions of the compartment for built-in installation are
shown in Fig. 1.
Prefit the 4 screws (see fig. 3) using the holes provided in the
front panel visible with the oven door open, making sure that
the tips of the screws go in the direction of the cabinet's wooden
element.
Fit the oven into the unit and screw in the screws until comple-
tely tight.
If the oven is to be installed close to other household appliances,
check that there will be no mutual interference during operation.
Their respective electrical connections must be separate.
Suitable ventilation should be assured by means of an opening
in the top of the column unit, or an opening of 10 mm above the
oven surround. See fig. 1.
CONNECTING TO THE ELECTRICAL MAINS
Before making the connection, check that:
- the mains voltage is as indicated on the nameplate;
- the earth connection is in good working order.
If the appliance power lead is not fitted with a plug, use an ap-
proved standard type, remembering that:
- the green-yellow wire must be used for the earth connection;
- the blue wire is the neutral;
- the brown wire is live;
- the lead must never touch hot surfaces over about 75 degrees
C;
- replacement leads must be of type H05VV-F of suitable size
(see diagrams in fig. 2).
- if the appliance is supplied without lead, using type H05VV-F
cable of suitable size (see diagrams in fig. 2).
N.B. The plug must be reachable when the appliance is installed
IMPORTANT: the manufacturer declines all liability for damage
due to failure to comply with the regulations and standards in
force. Check that the appliance is correctly connected to the
earth (see diagrams in fig. 2 at the back of the manual).
Installation
.
HOW TO USE THE OVEN
STATIC ELECTRIC OVEN
There is a single control knob for the oven or grill.
Starting from the 0 (off) position, the knob can be turned clock-
wise to the following settings:
- symbol : oven lamp on (it will remain on even if the knob
pointer is turned to the other settings).
- Setting from 50 to 250 degrees C : oven heat settings, with
thermostat control.
- symbol , or
- symbol : rotisserie start with grill on.
Turn the knob anti-clockwise to return to the 0 (off) position.
N.B. - The yellow light switches on and off as the thermostat
is tripped.
Before placing food inside, allow the oven to heat up for at least
10 minutes.
STATIC ELECTRIC OVEN 4
With different heating elements controlled using a selector switch
and regulated by a thermostat,starting from the 0 (off) position,
as the knob is turned clockwise the settings available are:
- symbol : the oven light is switched on (it will always remain
on even when the knob pointer is turned to the other settings).
- symbol , or : grill (in top of oven) is switched on.
- symbol , : roaster switches on with grill on.
- symbol : oven top and bottom elements switch on (con-
ventional cooking function). To regulate the temperature, use
the knob of the thermostat
50° to 250°C.
N.B. - The yellow light switches on and off as the thermostat is
tripped.Before placing food for cooking inside, allow the oven
to heat up for at least 10 minutes.
STATIC ELECTRIC OVEN " 4 New "
With different heating elements controlled using a selector switch
and regulated by a thermostat, starting from the 0 (off) position,
the knob can be turned clockwise to the following settings:
- symbol :oven lamp on (it will remain on even if the knob
pointer is turned to the other settings).
- symbol :slow cooking using the bottom element; the
oven temperature is regulated using the thermostat knob.
- symbol :conventional "static" oven cooking, the oven
temperature is controlled using the thermostat knob.
- symbol :grill on.
N.B. - The yellow light switches on and off as the thermostat
is tripped.
Before placing food inside, allow the oven to heat up for at least
10 minutes
ELECTRIC FAN OVEN WITH 4 COOKING PROGRAMS
With different heating elements controlled using a selector switch
and regulated by a thermostat, starting from the 0 (off) position,
the knob can be turned clockwise to the following settings:
- symbol : oven lamp on (it will remain on even if the knob
pointer is turned to the other settings).
- symbol : operation of fan.
- symbol : cooking with fan oven, on one or two levels, the
oven temperature is controlled using the thermostat knob.
- symbol : grill on.
MULTIFUNCTIONS ELECTRIC OVEN 4 POSITIONS
With different heating elements controlled using a selector switch
and regulated by a thermostat, starting from the 0 (off) position,
the knob can be turned clockwise to the following settings:
- symbol : oven lamp on (it will remain on even if the knob
pointer is turned to the other settings).
- symbol :conventional "static" oven cooking, the oven tem-

For the user

: grill on (in roof of oven)
: oven heat settings rising from