For The Installation Engineer; Technical.data; Pre-Installation.procedures; Building.in.the.oven - Bompani BO243 Instruction Manual

AUS
•.Do.not.spray.aerosols.in.the.vicinity.of.this.appliance.while.iy.is.in.operation.
WARNING:.Do.not.touch.the.oven.heating.element.
WARNING:.Make.sure.that.the.appliance.is.switched.off.before.changing.the.light.bulb.to.avoid.electric.shock.
5.3 ENVIRONMENTAL PROTECTION AND SAVING
.•.Using.the.oven.between.late.afternoon.and.early.morning.helps.to.reduce.demand.peaks.
.•.Keeping.the.oven.door.gaskets.clean.and.in.good.condition,.so.that.they.adhere.to.the..door.firmly,.reduces.heat.loss.

6.FOR THE INSTALLATION ENGINEER

The appliance must be installed by a qualified person, who must follow the instructions provided in this manual and in the
regulations:Law n. 46 of 05.03.1990 – Regulations on the Safety of Systems
6.1. Technical Data
Heating Element Power
Bottom.heating.element.. .
Top.-.bottom.heating.element..
Fan.heating.element..
Oven.light.. .
Cooling.fan.(where.installed)........................................22-26.W
Oven.fan............................................................................25.W
Power.supply.voltage.(50-60Hz)......................................240.V
Oven usable dimensions
Width............................................................................mm..411
Depth............................................................................mm..391
Height...........................................................................mm..330
Volume................................................................................l..58
Usable dimensions of cavity in building-in cabinet
Height..........................................................................mm..584
Width...........................................................................mm..564
Depth...........................................................................mm..550
6.2 Pre-Installation Procedures
•.Unpack.the.appliance.and.recycle.the.packaging.material.in.accordance.with.the.relevant.regulations.
•.After.unpacking,.check.the.appliance.for.damage..If.in.doubt,.do.not.use.the.appliance.and.contact.a.qualified.professional..(See.
After-Sales.Service).
•.The.packaging.materials.(plastic.bags,.expanded.polystyrene,.nails,.etc.).must.not.be.left.within.reach.of.children.since.they.are.
potentially.hazardous.
•.Check.that.the.accessories.are.in.the.bottom.of.the.packaging..
•.Do.not.make.improper.use.of.the.oven.door.handle.during.transport.and.installation.
6.3 Building-In the Oven
.•..In.order.to.allow.the.product.to.be.built.in.correctly,.the.cabinet.must.have.the.following.characteristics:
...-.the.panels.next.to.the.oven.must.be.in.heat-resistant.material;.
...-.if.the.cabinet.is.in.veneered.wood,.the.adhesive.used.must.withstand.a.temperature..of.100°C;
..-.when.building-in.the.oven,.whether.the.installation.is.under-counter.or.in.a.tall.unit,..the.cabinet.must.have.the.dimensions.stated.
in.Fig..1.–.page.17
.•..Place.the.oven.in.the.cabinet.and.screw.the.4.screws.fully.down,.using.the.holes.provided...in.the.facia,.visible.when.the.oven.door.
is.opened..Make.sure.that.the.screws.are.inserted.towards.the.centre.of.the.wood.in.the.cabinet:.(see.Fig.1-3-page.17)..Before.fixing.
the.screws,.also.ensure.that.the.oven.is.correctly.aligned.with.the.floor.with.the.aid.of.a.spirit.level.
.•..An.opening.in.the.top.of.the.tall.unit,.or.a.10.mm.gap.above.the.oven.surround,.should...be.provided.to.ensure.adequate.ventilation..
(see.Fig..1.-.page.17).
.•..If.the.oven.is.to.be.installed.close.to.another.appliance,.check.that.there.is.no.interference.between.the.two.devices.when.in.ope-
ration.
.•..Once.the.appliance.has.been.built.in,.no.contact.with.electrical.parts.must.be.possible..
6.4 Connecting to the electrical mains
For.direct.connection.to.the.mains,.a.mains.cut-off.device.with.a.contact.breaking.gap.that.ensures.complete.disconnection.in.category.
lll.overvoltage.conditions.must.be.provided,.in.accordance.with.the.installation.rules.
WARNING:.The.plug.must.be.reachable.when.the.appliance.is.installed.
Useful information for the installation engineer:
•.the.green-yellow.coloured.wire.must.be.used.to.make.the.earth.connection;
•.the.blue.wire.for.the.neutral;.
•.the.brown.wire.for.the.live.connection;.
•.the.cable.must.not.touch.hot.surfaces.with.a.temperature.over.75°C;.
•.if.the.cable.is.replaced,.the.new.one.must.be.of.H05RR-F.or.H05V2V2-F.type.of.suitable..gauge.(see..Fig..2.–.page.17);
. .
. .....1100-1500.W
. . .
. . .
1100.W
2000.W
....15.W
14
Instructions