Wiring Of Power Supply Unit - Furuno DRS4D Installation Manual

2.3

Wiring of Power Supply Unit

2.3.1 Wiring inside power supply unit PSU-013 (for DRS25A)
1. Detach the body cover by hand.
2. Loosen six pan head screws (M3x8) and slide the shield cover upward to remove it.
3. Unfasten four pan head screws (M14x10) to remove two cable clamps.
Pan head screws
(M4x10, 4 pcs.)
Cable clamps
4. Connect the VL3P-VV-S2X2C-AA050 and MOD-ASW0002 cables (supplied) to appropriate
connectors in the power supply unit as shown below.
hen the power supply unit is connected to TZT9/14/BB, attach the XH
Note: W
Connector Asembly (supplied with PSU-013) to J7 on the PWR board. For
details, see "How to connect TZT9/14/BB" (supplied with PSU-013).
VL3P-VV-S2X2C-AA050 cable
5. Remove two cable clamps, shield cover and body cover in that order.
6. Connect other cables.
1: Red
2: N. C.
White
Black
J7
MOD-ASW0002 cable
(Power)
23
Body cover
Shield cover
Pan head screws
(M3x8, 6 pcs.)
3: Blue
2: Black
1: White