Table of Contents
Advertisement
Available languages
Available languages
Minimum spacing for recessed area
or closet installation
The dimensions shown following are for the minimum spacing
allowed.
Additional spacing should be considered for ease of
■
installation and servicing.
Additional clearances might be required for wall, door,
■
and floor moldings.
Additional spacing of 1" (25 mm) on all sides of the dryer
■
is recommended to reduce noise transfer.
For closet installation, with a door, minimum ventilation
■
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings
are acceptable.
Companion appliance spacing should also be considered.
■
Minimum Required Spacing
Recessed Area Installation
14" max
(356 mm)
0"
(0 mm)
(0 mm)
Closet Installation
14" max
(356 mm)
0"
(0 mm)
0"
(0 mm)
Additional spacing recommended
15"
(381 mm)
0"
(0 mm)
0"
3"/3"
(76 mm)
48"
(310 cm
15"
(381 mm)
24"
(155 cm
3"/3"
(76 mm)
1"
(25 mm)
Mobile home – Additional installation requirements
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280) or the Canadian
Manufactured Home Standard CAN/CSA-Z240 MH.
Metal exhaust system hardware, which is available
■
for purchase. For further information, please reference the
"Assistance or Service" section of the Use and Care Guide.
Special provisions must be made in mobile homes to
■
introduce outside air into the dryer. The opening (such
as a nearby window) should be at least twice as large
as the dryer exhaust opening.
/48"
2
2
)
2
24"
2/
2
)
2
7
Advertisement
Table of Contents
