Brinkmann 810-8503-SB Owner's Manual page 26

Step 10
Remove front bolt from the left side
of the grill assembly control panel
as shown. Place the four key holes
on the sear burner assembly over
the four pre-attached bolts on the
left side of the cart frame assembly,
and slide toward the front of the
grill to lock. Tighten bolts securely,
and reinsert bolt to fasten the front
panel.
Step 11
Remove two M4 bolts from the sear
burner valve. Insert the sear burner
valve assembly through the hole in
the sear burner table base. Hold in
place while you perform Step 12.
Step 12
Place the bezel over the control
knob mounting stem and position
over holes in sear burner base and
sear burner valve assembly. Attach
with two M4 x 10 mm bolts which
come with valve. Then install the
sear burner control knob onto valve
stem.
Note: Align bezel with stop pin
hole toward bottom as
shown.
25
Sear Burner
Control Knob
Sear Burner Valve
Bezel
Stop Pin
Hole