Advertisement
Setting ON/OFF Angles in Manual Mode
ON/OFF angles can be set manually using the ANGLE Keys
on the front of the Cam Positioner.
Example: Setting Step 1 of Cam No. 2 to Turn ON at 28° and
Turn OFF at 51°
Change the mode.
Set the mode switch to PRGM.
Set the programming
Set the programming mode switch to MAN.
mode switch.
Mode
PRGM
TEST
RUN
Banks can be specified only for
Set the bank No.
16-/32-output models.
• Press the
Key to specify the bank number and
BANK
then press the
Key.
WRITE
Set the cam and step No.
• Press the CAM Keys
• Press the STEP Keys
STEP
CAM
Set the ON angle.
• Press the
ON↑ ↓OFF
Key to flash the
• Press the ANGLE Keys
and then press the
WRITE
CAM
STEP
Set the OFF angle.
• Press the
ON↑ ↓OFF
Key to flash the
• Press the ANGLE Keys
press the
Key.
WRITE
CAM
STEP
End
Note: Pressing the
or
Key continually will automatically increment or
decrement the value. Pressing the other key during automatic increment
or decrement will increase the speed.
Programming mode
TCH
MAN
to specify cam No. 2.
to specify step No. 1.
PRG
"
"
.
ON↑
to set an angle of 28
Key.
PRG
↓OFF
"
"
.
to set an angle of 51 and then
PRG
Setting ON/OFF Angles in Teaching
Mode
ON/OFF angles can be set based on actual machine (Encoder)
operation.
Example: Setting the ON/OFF Angles by Teaching Step 2 of
Cam No. 3
Change the mode.
Set the mode switch to PRGM.
Set the programming
Set the programming mode switch to TCH.
mode switch.
Mode
PRGM
TEST
RUN
Banks can be specified only for
Set the bank No.
16-/32-output models.
• Press the
Key to specify the bank number and
BANK
then press the
Key.
WRITE
Set the cam and step No.
• Press the CAM Keys
• Press the STEP Keys
STEP
CAM
Set the ON angle.
• Press the
ON↑ ↓OFF
Key to flash the
• Turn the machine (Encoder) to the desired ON angle.
(195° in this example)
• Press the
Key.
WRITE
CAM
STEP
Set the OFF angle.
• Press the
ON↑ ↓OFF
Key to flash the
• Turn the machine (Encoder) to the desired OFF angle.
(278° in this example)
• Press the
Key.
WRITE
CAM
STEP
End
H8PS
Programming mode
TCH
MAN
to specify cam No. 3.
to specify step No. 2.
TST
"
"
ON↑
.
TST
↓OFF
"
"
.
TST
22
Advertisement
