Ranger design 1530-NS Installation Manual page 10

1.2.6 • Pull out the 14.5" track plug on both ends of the front crossbow.
• Loosen the pre-assembled hardware on the front hooks and slide the hooks onto the
front crossbow to the position shown below.
• Cut the track plug, then attach it back to the crossbow.
For technical support, contact us at 1-800-565-5321
Tighten the nuts just to hold the front
hook for adjustment.
TOOLS
q Marker
q Cutter
HARDWARE USED
4×
-
hardware is pre assembled
#90-491 Carriage Bolt 5/16" × 1"
#98-117 Flat Washer
#98-123 Lock Washer
#94-105 Hex Nut
1530-NS Installation Guide | REV. D2 | Page 10
.