Sony MSU-700A Operation Manual page 42

Locations and Functions of Parts
qaIC card insertion block
1
1 IC card slot
Insert an IC card (which conforms to PCMCIA) to
store reference files, lens files and scene files of the
video camera or CCU.
It also permits the configuration of the CNU-700 and
software installation for version up.
To insert a card
Slide the cover to open the IC card insertion block.
1
Insert the card into the slot.
2
When the card is correctly set, the ACCESS indicator
lights in green.
Note
The data in the memory card is maintained by the
battery built into the card. If the battery is exhausted,
the data in the card will be lost. You can check the
battery condition by the ACCESS indicator. If the
battery becomes weak, replace the battery with a new
one as soon as possible.
2 Eject button
Press to eject the inserted IC card.
Note
Do not eject a card when the ACCESS indicator is lit
in red (it means that the data is being read from or
written to the card). This may erase data stored in the
card.
8 (E)
2
ACCESS
3
3 ACCESS indicator
Shows the status of the IC memory card.
Indication Meaning or Measures
Off No card is inserted.
Lit in green There is a card in the slot. (The battery
condition is good.)
Lit in orange The battery of the card in the slot
begins losing its charge. Although the
data are still maintained, replace the
battery at the earliest opportunity.
Flashes in orange The battery of the card in the slot is
almost exhausted. While the card
stays in the MSU-700A, the MSU-700A
supplies the power to the card.
However when the card is ejected, the
data cannot be maintained. Replace
the battery before using.
Lit in red Data are being read/written. If you
eject the disc in this condition, the data
is not guaranteed. All the data may be
lost.
For battery replacement, refer to the instructions for the IC
card.
qsPICTURE MONITOR buttons
Press to select the output signal from the PIX2
OUTPUT connector of CCU.
The signal corresponding to the lit button is output.
R/G/B: Select the R signal, G signal, or B signal. The
signals can be selected either independently or in
combination. When any of these buttons is
pressed, the ENC circuit is turned off.
ENC (encode): When this button is pressed, the R/G/
B circuits are turned off, and the ENC signal is
output.
qdWAVEFORM MONITOR buttons
Press to select the output signal from the WF2
OUTPUT connector of CCU.
The signal corresponding to the lit button is output.
R/G/B: Select the R signal, G signal, or B signal. The
signals can be selected either independently or in
combination. When any of these buttons is
pressed, the SEQ and ENC circuits are turned off.
SEQ (sequence): When this button is pressed, the R/
G/B circuits are turned off, and the SEQ signal is
output. You can monitor the waveforms of the
three R, G, and B signals in sequence on a
waveform monitor.
ENC (encode): When this button is pressed, the R/G/
B and SEQ circuits are turned off, and the ENC
signal is output.