Ricoh D649 Field Service Manual page 116

4. Service Tables
T0 timer adjustment
Bit 5
0
4-5
0
1
1
6-7 Not used
No.
Network I/F setting for SIP connection
0 0: IPv4
1: IPv6.
Network I/F setting for Fax
communication
1
0: Same setting as SIP server connection
1: Automatic setting
Record-route setting
2 0: Disable
1: Enable
re-INVITE transmission delay timer
setting
Bit 4
0
3-4
0
1
1
114
Bit 4
0 75 s
1 120 s
0 180 s
1 240 s
IP Fax Switch 09 (SP No. 1-111-010)
Function
Bit 3
0 No delay
1 1 sec
0 2 sec
1 3 sec
Adjusts the fail safe timer. This timer sets the
interval between "setup" data transmission and T.
38 phase decision. If your destination return is
late on the network or G3 fax return is late, adjust
the longer interval timer.
The default is "00" (75 seconds).
Do not change these settings.
Comments
Selects the connection type (IPV4 or IPV6) to
connect to the SIP server.
0: The I/F setting for fax communication follows
the setting for SIP server connection.
1: The negotiation between the SIP server and the
device decides whether IPv4 or IPv6 is used for
the I/F setting for fax communication.
0: Disables the record-route function of the SIP
server.
1: Enables the record-route function of the SIP
server.
This changes the interval for transmit re-INVITE
after receiving the ACK message transmitted by T.
38 device.