Ricoh D649 Field Service Manual page 112

4. Service Tables
SIP transport setting
2 0: TCP
1: UDP
CCM connection
3 0: No CCM connection
1: CCM connection
Message reception selection from non-
registered SIP server
4
0: Answer
1: Not answer
ECM communication setting
5 0: No limit for image compression
1: Limit for image compression
6-7 Not used
No.
Effective field limitation for G3 standard
function information
0
0: OFF, 1: 4byte (DIS)
Switching between G3 standard and
G3 non standard
1
0: Enable switching
1: G3 standard only
AI modem rate function
2
0: OFF, 1: ON (enable)
ECM frame size selection at transmitting
3
0: 256byte, 1: 64byte
110
IP Fax Switch 03 (SP No. 1-111-004)
Function
This bit switch sets the transport that has priority for
receiving IP Fax data.
This function is activated only when the sender has
both TCP and UDP.
When "1" is selected, only the connection call
message with H.323 or no tunneled H.245 is
transmitted via CCM.
0: This answers the INVITE message from the SIP
server not registered for the machine.
1: This does not receive the INVITE message from
the SIP server not registered for the machine and
send a refusal message.
0: This does not limit the type of the image
compression with ECM communication.
1: When the other end machine is Cisco, this
permits the image compression other than JBIG or
MMR with ECM communication.
Do not change these settings.
Comments
Limits the effective field for standard G3 function
information.
Enables/disables switching between G3 standard
and G3 non-standard.
Enables/disables the AI modem rate.
Selects the ECM frame size for sending.