Kohler Dolce Vita K-2815 Installation Manual page 8

Install the Lavatory (cont.)
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
Self-Rimming Installations
Cut out the opening by carefully following the pencil line traced
from the template.
CAUTION: Risk of personal injury or product damage. Cast
iron lavatories are very heavy. Get help lifting the lavatory into
place.
Temporarily position the lavatory in the countertop cutout so the
"Kohler" logo is to the back. Adjust to fit.
Remove the lavatory.
Drill the faucet holes.
Install the faucet and drain according to the manufacturer's
instructions.
Clean the countertop, and carefully position the lavatory in the
countertop opening so the "Kohler" logo is to the back.
Apply a thin, continuous bead of sealant around the lavatory
edges.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Verify that the lavatory has not moved out of position.
Allow the sealant to cure at least 30 minutes before proceeding.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
1018374-2-A 8 Kohler Co.