Troubleshooting - Progress PAI8100F User Manual

24 progress
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth
and some detergent.

TROUBLESHOOTING

Problem
You cannot activate the appli-
ance or operate it.
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds
when the appliance is deactiva-
ted.
The appliance deactivates.
The residual heat indicator
does not come on.
The heat setting changes be-
tween two levels.
The sensor fields become hot.
comes on.
comes on.
comes on.
and a number come on.
3. At the end rub the appliance dry
Possible cause
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the sen-
sor field .
The cooking zone is not hot
because it operated only for a
short time.
The Power management is ac-
tivated.
The cookware is too large or
you put it too near to the con-
trols.
The Automatic Switch Off op-
erates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cook-
ing zone.
The cookware is incorrect.
The diameter of the bottom of
the cookware is too small for
the cooking zone.
There is an error in the appli-
ance.
with a clean cloth.
Activate the appliance again
and set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the cooking zone operated
sufficiently long to be hot, speak
to the service centre.
Refer to "Power management".
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and
activate it again.
Refer to the chapter "Daily Use".
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller
cooking zone.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
Remedy