Table of Contents
Advertisement
SAFETY CHECK
1. Brakes
2. Wheels and Tyres
3. Steering
4. Chain
5. Bearings
6. Cranks and Pedals
7. Derailleurs
8. Frame and Fork
9. Accessories
10. Motor Drive Assembly and
Throttle
11. Battery Pack
WATTWHEELS LTD
BASIC STEPS
o Ensure front and rear brakes work properly.
o Ensure brake pads are not over worn and are correctly positioned in relation to the disc.
o Ensure brake hoses are correctly bleed and display no obvious wear.
o Ensure tyres are inflated to within the recommended limits displayed on the tyre sidewalls.
o Ensure tyres have tread and have no BULGES OR EXCESSIVE WEAR.
o Ensure rims run true and have no obvious wobbles or kinks.
o Ensure all spokes are tight and not broken.
o Check axle nuts and quick releases to ensure they are tight. If your bicycle is outfitted with quick release axles, ensure the locking
levers are correctly tensioned and in the closed position.
o Ensure the handlebar and stem are correctly adjusted and tightened and allow proper steering.
o Ensure the handlebars are set correctly in relation to the forks and the direction of travel.
o Ensure the chain is lubed, clean and runs smoothly.
o Extra care is required in wet or dusty conditions
o Ensure all bearings are lubricated, run freely and display no excess movement, grinding or rattling.
o Check headset, wheel bearings, pedal bearings and bottom bracket bearings.
o Ensure pedals are securely tightened to the cranks.
o Ensure the cranks are securely tightened and are not bent.
o Check that the derailleur is adjusted and functioning properly.
o Ensure shift and brake levers are attached to the handlebar securely.
o Ensure shift cables are properly lubricated.
o Check that the frame and fork are not bent or broken.
o If either are bent or broken, they should be replaced.
o Ensure all reflectors are properly fitted and not obscured.
o Ensure all other fitting on the bike are properly secured and functioning.
o Ensure rider is wearing a helmet and any other required riding safety gear.
o Ensure mid-motor is spinning smoothly and the motor bearings are in good working order.
o Ensure battery is charged before use.
o Ensure there is no damage to battery pack.
o Lock battery to frame and check to see that it is secured.
16
Advertisement
Table of Contents
