S/Pdif Connector; Smbus Connector - DFI SU173 User Manual

S/PDIF Connector

1
+5V
Key
SPDIF out
S/PDIF
Ground
SPDIF in
5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
Chapter 2 Hardware Installation
Chapter 2

SMBus Connector

The SMBus (System Management Bus) connector is used to connect SMBus devices. It is a
multiple device bus that allows multiple chips to connect to the same bus and enable each one
to act as a master by initiating data transfer.
25
SMBus
6
2
1 5
www.dfi.com