Rear Panel I/O Ports; Dc-In (Su171)/15~36V Dc-In (Su173) - DFI SU173 User Manual

Rear Panel I/O Ports

DC-in
HDMI/DP
DP++
The rear panel I/O ports consist of the following:
• 1 12V DC-in jack (default) - SU171
• 1 15~36V DC-in jack (default) - SU173
• 1 HDMI/DP port (DP available upon request)
• 1 DP++ port
• 2 RJ45 LAN ports
• 4 USB 3.0 ports
• 1 Line-out jack
• 1 Mic-in jack
Chapter 2 Hardware Installation
USB 3.0
LAN 1 LAN 2
Mic-in
Line-out
Chapter 2
12V DC-in (SU171)/15~36V DC-in (SU173)
DC-in
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range may fail to boot the system or cause damage to
the system board.
The DC-in jack on the system board co-lays with a 4-pin right angle connector (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
4-pin Right Angle
(optional)
17
4-pin Vertical Type (optional)
DC-in (default)
www.dfi.com