Changing The Presser Foot; How To Use The Presser Foot - JUKI MO-2800 Instruction Manual

Using the machine
C
8.5mm
10mm

Changing the presser foot

• Raise the presser foot.
• Turn handwheel towards you until needles are fully raised. Match the
matching up marks on handwheel and side cover.
Press the catch (C) to release the presser foot from the clamp. Raise the
presser foot shank to the highest position (B) and remove the presser foot
to the left. To attach the presser foot, place it under the shaft. The groove
in the shaft should line up exactly with the presser foot pin (D). Lower the
presser foot lifting lever and check that the groove in the shank should line
up exactly with the presser foot pin (D). If it is not lined up, press the catch (C)
to line up.
D

How to use the presser foot

Use the marker on the presser foot as a guide when placing the material
under the presser foot.
(F) Left needle position
(G) Right needle position
(H) Knife position (when the cutting width adjusting dial is set at scale mark
"3.0")
The knife position represents the position at which the material is cut.
F
G
H
・ Curve foot
The curve foot is able to make small turns since it is smaller than the stan-
dard presser foot. It is useful for sewing small curves.
When you want to change the presser foot, turn
CAUTION
OFF the power switch and lower the upper knife.
10