Select The Delay Start; Start The Programme; How To Change An Option Or A Programme During Its Cycle; How To Cancel A Programme - John Lewis JLWM1603 Instruction Manual

The end cycle will be updated and shown on the
relative position of the display.

10. Start the programme

Press the "Start/Pause" button. The relevant light will
stop flashing. The message relevant to the phase that is
in progress will be shown in the display.
If you have chosen a delayed start, the washing machine
will begin the countdown.
11. How to change an option
or a programme during its
cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the "Start/Pause"
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to
"Off" and then to the new programme position. The
washing water in the tub will not be emptied out .
Start the new programme by depressing the
"Start/Pause" button.
Note: To drain the water before starting the new cycle
you have to cancel the programme and select the
"Drain" programme.
12. Cancelling a programme
Turn the selector dial to "Off" to cancel a programme
which is running. Now you can select a new programme.
13. How to open the door
during a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the relevant message appears in the
display and the door can be opened.
Should it not be possible to open the door, the "Door
locked" message appears in the display and the door
locked light is on, should it be absolutely necessary to
do so, switch the machine off by turning the selector
dial on "Off" position.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!

14. End of programme

At the end of the programme, the washing machine
stops automatically, gives an audible signal (if option no
sound has not been selected), and displays the relevant
message.
If you had selected the
"Start/Pause" button light is off and the "Cycle
ended/ Door locked" message appears in the display.
To drain or spin first turn the programme selector dial
to "Off" and then to "Drain" programme or
"Spin"/Delicate Spin" programme .
Release of the lock is also indicated by the message
"Door openable" (cycle ended) being displayed.
Turn the programme selector dial to "Off" to switch
the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
14
or option, the