Record Control; Advanced - Dahua NVR608-32-4KS2 User Manual


If the image upload interval is smaller than the snapshot frequency, system will upload at the
snapshot frequency. For example, if the image interval is 5 seconds and the snapshot frequency
is 10 seconds, system will send out the image at 10 seconds.

From main menu->Setting->Camera->Encode->Snapshot to set snapshot frequency.

Channel: Select a channel from the dropdown list and then set week, period and record type.

Week day/Period: Please select from the dropdown list and for each day, you can set two periods.

Type: Please select uploaded record type (Alarm/intelligent/motion detect/regular). Please check the
box to select upload type.

4.6.5.5 Record Control

From main menu>Setup>Storage>Record, the interface is shown as in Figure 4-120.
Please refer to the following sheet for detailed information.
Parameter
Channel
Status
Schedule
Manual
Stop
Start all/
stop all

4.6.5.6 Advanced

Figure 4-120
Function
Here you can view channel number.
The number displayed here is the max channel amount of your
device.
There are three statuses: schedule, manual and stop.
System enables auto record function as you set in record schedule
setup (general, motion detect and alarm).
It has the highest priority.
Enable corresponding channel to record no matter what period
applied in the record setup.
Stop current channel record no matter what period applied in the
record setup.
Check the corresponding All button, you can enable or disable all
channels record.
340